Installation - Waring WPC100 Manual

INSTALLATION

Carefully remove the Pasta Cooker from the packaging and place the
unit on a firm, level surface.
Use only the baskets provided with the unit. DO NOT substitute the
baskets or attempt to replace the baskets.
This unit is to be installed with adequate backflow protection to
comply with applicable federal, state, and local codes.
This unit can also be used as a stand-alone, without external
plumbing connections.
STAND ALONE INSTRUCTIONS FOR
INSTALLATION
Make sure all three valves are in the closed position. There are two
located in the front of the unit and one located on the back of the
unit. Fill unit with a bucket of tap water up to the fill line (just below
the overflow drain).
PLUMBED INSTRUCTIONS FOR INSTALLATION
Connect to the refill (located on back of pasta cooker) and overflow
plumbing connections.
The refill plumbing connection is a male NPT ½ x 12. The overflow
plumbing connection is a female NPT ½ x 12.
If connecting to an outside water line, the plumbing connections must
contain water pressurized at or below Water Line Pressure and at or
below 40˚C (104˚F) during normal operation. If using a rubber hose:
It must have a Reinforcing Outer Braid, and have a manufacturer's
rating of at least 200 psig.
Make sure the water overflow outlet valve (located on back of pasta
cooker) is in the open position. Open the water refill valve (located
on the front of the pasta cooker) to fill the basin with water. The valve
can be adjusted between open and close positions to control the
water flow into the basin.
BACK FRONT
7