Advertisement
Available languages
Available languages
EN
џ Disable the internet connection of the device.
Enable the GPS location service of the device.
џ
Activate the WiFi module of the device and connect it with the network created by the module (ELD-....).
џ
џ The password is: Incotex123
If the device does not find the WiFi network created by the module, please repeat step 1 or restart the WiFi module on the
џ
device (turn it off and on again).
If the device and module are connected successfully, the screen of the regulator will display the Internet connection symbol
џ
D
STEP 3. CONNECTING THE MODULE TO THE INTERNET, THROUGH THE DEVICE.
џ Start the Eldom application. Set the preferred language.
џ Select the Local option
џ Select Add New Device. A confirmation may be required to use the device location from the application. Permit the use.
џ Select the appliance detected and confirm your selection with OK.
џ The screen of the regulator will display a connection message. Press the OK button.
џ The screen of the device will display the unit found. Select it.
џ From the Syst.sett. menu of the application select Network Settings.
џ In the "For connection via the Internet" section enter the network name/password.
џ Save the entry. The screen of the device will display a brief message that the network is stored.
џ Cut the connection between the module and device. Disable the WiFi on the device, connect it to
another network or switch over to mobile data.
џ In the New WiFi Network menu of the regulator, select mode WiFi On.
After these steps are implemented, your convector heater is connected to the Eldom remote control and
monitoring system. Subsequent control and monitoring of unit operation is carried out by application
option via the Internet.
It is possible for the "Added New Device" to be controlled by several devices at the same time, as long as
the Eldom application is installed on them, and the application uses the same registered user (account -
username and password).
SERVICE AND MAINTENANCE
Never clean convector while plugged in, when running or hot!
In order to preserve the unit technical characteristics and to prevent overheating is necessary, for example, once a month to clean
џ
the accumulated dust from the heater top and bottom grid with a vacuum cleaner.
Clean the body with a dry cloth, vacuum cleaner or brush
џ
It is prohibited to use liquids when cleaning the unit.
џ
Do not use abrasive materials!
џ
WARNING! After cleaning the heater it is compulsory to place it back in its normal position (according to fig. 1), before switching it on.
ADVICES FOR APPLIANCE PROPER USE
It is not necessary to set the unit in operation at highest temperature, the degrees in the room shall not climb up quicker.
When aerating the room use button 2 to switch off the unit or the clutch of the right side panel.
When leaving home for few hours mind decreasing the temperature set.
Should you be absent for:
less than two hours it is not necessary to change the temperature set.
џ
from 2 (say: two) to 24 (say: twenty four) hours you may decrease temperature set with few degrees.
џ
for more than 24 (say: twenty four) hours or in summertime - you may leave the device plugged in with the key turned on with the
џ
thermostat set to a minimum temperature. You shall thus activate the unit anti-freeze mode.
If you have more than one electric convertor in the room you may switch them on simultaneously, thus securing constant temperature
without increasing power consumption. It is true also for rooms which are not permanently used – it is better to leave the units switched on
at minimum temperature stings than to switch them off completely.
WARRANTY, WARRANTY PERIOD AND WARRANTY CONDITIONS
The warranty, warranty conditions, warranty period, warranty validity for purchased appliance and service related manufacturer or vendor
liabilities during the appliance warranty period are listed in the appliance warranty form. When buying the appliance the warranty form
must be filled and signed both by seller and buyer. Keep the warranty form in a secure place.
20
EN
Advertisement
