Advertisement
Available languages
Available languages
EN
Pressing ▲ or ▼ button again moves to the hourly average room temperature graphs. The controller shall store
such information for the last 4 days. By pressing the ▲ or ▼ buttons, the charts shall change with the days for
which information is available. Below each graph is the date to which it refers.
Additional information
The display may show additional information such as:
Information about the condition of the WiFi module It is necessary to press the OK button once, then the ▼
button. If you purchased a device without WiFi control, the message No WiFi module shall be displayed.
Information about the controller hardware and software versions. It is necessary to press the OK button once,
then press ▼ twice.
Information about the appliance operation errors. All error messages are displayed in the corresponding field on
the display. Messages can be as follows:
Disconnected TS
TS short-circuit
Open window
Fallen appliance /
Colaps. devoce
Wrong Time !
CONNECTING AN ELECTRIC CONVECTOR HEATER WITH ELECTRONIC CONTROL AND WIFI
MODULE TO THE REMOTE CONTROL AND MONITORING NETWORK SYSTEM
WARNING! Connecting the convector heater to the Internet is optional and is not specifically required for the operation of the
convector heater as intended!
Terms used in this section are:
џ
„module" – the WiFi module of the electronic thermoregulator (electronic control) of your convector heater.
„regulator" – the electronic thermoregulator (electronic control) of your convector heater.
џ
„device" - a smartphone, tablet or laptop, which is used to connect the WiFi module to the Internet and to enable its remote control
џ
and monitoring.
„WiFi network" – the wireless network (WiFi) created by the module.
џ
„network" – the wireless network (WiFi) to which you want to connect the module. It is created by a router/modem, must have
џ
internet access and be near the unit.
„system" – the Eldom web-based remote control and monitoring system.
џ
ATTENTION! The module is connected to the regulator and is controlled by it!
ATTENTION! You must connect the module to the Internet to enable the remote control and monitoring of the unit operation!
ATTENTION! You need a device to connect the module to the system.
ATTENTION! You need to download the Eldom application on your device from Google Play or Аpp Store. The minimum version of the
Android operating system on your device is 8.0.
ATTENTION! You need to have a registration (account) in the Eldom application in order to control and monitor the operation of your
convector heater.
The module is connected to the Internet in 3 main steps.
Step 1. Setting up a WiFi network by the module
Step 2. Connecting the device to the module
Step 3. Connecting the module to the internet, through the device
Subsequent remote control and monitoring of unit operation is implemented through the system.
STEP 1. CREATING A WIFI NETWORK BY THE MODULE
џ In the New WiFi Network menu select mode AP On.
STEP 2. CONNECTING THE DEVICE TO THE MODULE
The room temperature sensor is switched off or interrupted.
The heater shall not work
The room temperature sensor is short-circuited. The heater shall not work.
The Open window mode is enabled.
Enabled protection when the appliance is decommissioned
The watch is not set. The weekly programmer will not work.
19
EN
Advertisement
