Advertisement
INSTALLATION
Recommendations
Carefully choose the mounting location so that the unit won't interfere with normal driving.
l
l
vibration.
The illustration below shows a typical installation, however, you may need to adjust the installation, depending on the unit. If you have questions or need additional installation
l
hardware, consult your Elaupunkt dealer.
Make sure the unit is firmly anchored (preferably at both front and back)
l
and does not vibrate.
Mounting the Unit in a Japanese Car
You
may have dtffrculty mountrng this unit in some Japanese cars
In thus case, consult your Blaupunkt dealer.
Removing the Unit
Use the Release Keys as shown below. Keep them in a safe place in case you need them
MAINTENANCE
Fuse Replacement
When replacrng the fuse, be sure to use one with the correct amperage. whrch will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one
SPECIFICATIONS
Audio Power Soecifications
Power Output end Total Harmonic Distortion: 10 watts per channel mrnimum continuous average output into 4 ohms, 4 channels driven, from 30-15000 Hz with no more than 1%
total harmonrc drstortron.
Tuner
FM
Tuning Range:
87.5
108.0 MHz
07.5
10.7 MHz
18 dBf
FM Mono Sensrtrvrtv:
Selectivity:
75 dB at 400 kHz
Signal-to-Noise
Ratio:
65 dB (stereo), 70 dB (mono)
Harmonic distortion at 1 kHz:
0.7% (stereo), 0.5% (mono)
Separation:
30 dB
30-l 5,000 Hz f 3 dB
Frequency
Response:
AM
Tuning Range:
531-l ,602 kHz
530-1.710 kHz
55 dBuV
Seek lo sensrtivrty
Seek sensrtivrty:
35 dBpV
450 kHz
45 dB
Mounting The Unit In Most Dashboards
Install the Sleeve in the dashboard.
Select and bend the appropriate tabs to hold the sleeve firmly in place.
2
A.
Attach the Mounting Strap to the underside of the dashboard, using screw.
3
B.
Anach the back of the unit to the mounting strap using the support stem bolt and hardware,
I
Audio
Speaker Impedance:
MHz
Maximum Amp Power:
RMS Power:
Bass Control:
Treble Control:
Cassette
Signal-to-Noise Ratio:
Tape Wow and Flutter:
Tape Frequency Response:
General
Dimensions (w/o projecting parts/controls):
Mass.
Power Requirement (neg. grnd.):
Operating Temperature:
where it would subject to dust, dirt or excessive
Bend these tabs
I
30 Watts x 4 (at 4 ohms)
53 dB
0.10%
50-15.000 Hz f 3 dB
170 x 50 x 153.5 mm
7 x 2 x 6 in.
Approx. 1.4 kg (3.0 lb.)
12 V DC car battery
15°F to 12o"F, -10°C to 50°C
Unit
Faceplate
l
l
Mounting Hardware
. DIN Sleeve
l
Owner's Manual in English, French, Spanish and Portuguese
l
Advertisement
