Install The Second Display - FlyTech POS455 User Manual

Install the Second Display

4-5.
1. Follow the steps in Chapter 3-1 to diassemble the stand from the LCD panel.
2. Remove the thumb screw (x1) from the VESA top cover and then pull the cover up.
3. Attach the 8.4"' 2
4. Route the 2
5. Attach the stand to the LCD panel and
fasten the thumb screw (x1).
6. Connect the 2
port on the systems IO panel. Make
sure the system is powered off.
* Please note the cable cover and the
stand front cover (refer to Chapter 2-1
and 2-2) have to be removed before
routing the cable.
12
nd
display module to system by fastening the thumb screw (x1).
nd
display cable through the hole of the stand as picture shown.
nd
display cable to VGA