Waring WICSP180 Instruction Book page 5

INTRODUCTION
The Waring Commercial Gelato Panini Press is uniquely designed
®
to create a delicious new trend in frozen desserts called panini
gelato. The concept sandwiches a scoop of gelato, frozen yogurt
or ice cream and an optional topping in between a sweet bun. The
machine lightly sears the two halves of sweet bun together to lock in
the frozen dessert and toppings for a completely sealed pocket. The
delicate nature of the searing process allows chefs to seal the bun
together without melting the frozen dessert inside.
INSTRUCTIONS FOR USE
1. Before using your Waring
for the first time, remove any dust from shipping by wiping the
plates with a damp cloth. Remove all protective paper and
wrapping.
2. Plug cord into wall outlet.
Press the STANDBY button. The Power Indicator light will
illuminate (red) to signal that power is on. It will now begin the
preheating process. This should take about 4 minutes. The
machine will sound 6 beeps and the Ready Indicator light
(green) will go on to signal the unit is ready for baking.
NOTE: The first time you use your Gelato Panini Press, it may have
a slight odor and may smoke a bit. This is normal, and common to
heating appliances.
3. Set the desired time setting on your Gelato Panini Press
(from 5 to 15 seconds).
4. To prepare your gelato panini, cut a sweet bun, brioche roll or
thick slice of bread in half horizontally. Add spreads, gelato and/
or any other frozen dessert, and toppings to the bottom half.
Place the top half over the bottom half. Be sure all toppings are
completely covered by the bread.
5. Place the gelato panini into the cavity of the Gelato Panini
Press. Be sure to center the panini in the cavity, so that when
closed, all the edges of the bun, roll or bread will overlap the
cavity's flat outer rim. This will ensure all edges get pressed and
sealed.
6. Press the top heating plate over the gelato panini firmly and
press the START button to start the baking cycle. The green
LED light should blink during the baking cycle. Once the cycle
is complete, the unit will beep 3 times. Open the press and
remove your gelato panini using a nonmetal utensil.
7. Serve your gelato panini as desired.
Commercial Gelato Panini Press
®
5