Blaupunkt Alaska RDM168 Operating Instructions Manual page 8

MIX-ALL on:
Hold "5/MIX" depressed.
l
Press "5/MIX" to disactivate MIX.
Clock display
Press the DIS key when the unit is
turned on and the current time will be
shown for approximately 8 seconds.
Additional features of the clock display
Press and hold DIS key until it beeps
which will result in a permanent time
display.
When carrying out other functions, the
time display will be masked for approx-
imately 8 seconds.
You can customize certain basic unit
settings with DSC. Additional informa-
tion can be found in the section "Pro-
gramming with DSC".
This key activates the tone setting
menu. You can set different tone set-
tings for each operation mode. The last
setting for each operation mode will be
stored. (This applies only to the Ne-
vada RDM 168 and the Alaska RDM
168.)
8
Setting treble (high tones) and bass
(low tones):
Press the AUD key once. The display
will show "BASS" and you can change
the setting by pressing the toggle
switch either to the left or right.
You can change the treble setting by
pressing the rocker switches either up
or down while the display shows "TRE-
BLE".
The display will show the chosen val-
ues. The last value will be stored.
Press the AUD key to disactivate.
The AUD setting will end automatically
if there is no change within 8 seconds.
Setting balance (left/right) and fader
(front/back):
Press the AUD key two times.
By operating the rocker switches up or
down you can set the volume ratio be-
tween the front and the back speakers.
At the same time the display will indi-
cate "FADER".
Press the toggle switches to the left
and right to adjust the volume. At the
same time, the display will indicate
"BALANCE".
The display will show the selected val-
ues. The last value will be stored.
Press the AUD key to turn off.
The AUD setting will be end automati-
cally if there is no change within 8 sec-
onds.
To set the low tones appropriate for
the human ear at low volume levels.
Press the AUD key to turn the loud-
ness function on/off and hold the .key
down until you hear a beep. In units
with source tone memory, the loud-
ness function can be turned on and off
for each signal source independently.
Radio operation
Automatic tuning
Station search
A
V
down
Manual tuning
(in when off)
FM only AF turned