Blaupunkt Alaska RDM168 Operating Instructions Manual page 37

Cleaning the Connectors
The receiver may not operate properly if the connectors between the receiver and the detachable
face are contaminated with dirt. To clean the connectors, use a cotton swab and isopropyl alcohol
(90% or higher). Be sure to clean them with a vertical motion. Never clean them horizontally,
because this could damage the contact points.
Affixing the Detachable Face for Retail Display
The detachable face can be affixed to the receiver's chassis, which is desirable for a retail display.
To affix the face, obtain the small self-tapping screw from the hardware pack and drive it into the
upper hole at the front left side of the chassis using a Phillips screwdriver. The bolt will self-thread
the hole. (See Fig. 8)
Faceplate affixing screw goes here
TROUBLESHOOTING - Refer to the receiver's Owner's Manual. If you have questions, please
consult your Blaupunkt dealer or in the United States call l-800-266-2528.
Installer - These Installation Instructions are the property of the consumer!
8622401550
Make sure they are left in the vehicle!
Fig. 8
GB7