Siemens SIMATIC S7-300 Manual page 38

5 Commissioning of the Application
5.1 General preparations
No.
4. Confirm all dialog boxes with OK.
Then recompile the hardware configuration.
"Station > Save and Compile"
Parameterization and configuration for CP 441-2
Table 5-5
No.
1. CP_441-2 has the RS232 module at interface 1
and no module at interface 2. If the interface
assignment of your CP differs from the one de-
scribed above, HW Config must be changed
accordingly.
2. Open NetPro.
"Options > Configure Network"
3. Select the CPU of the S7-400 station. Create a
new connection.
"Insert > New Connection..."
38
Action
Action
Remark
Remark
Communication with a serial CP requires that a
connection be configured in NetPro. For a
configuring guide for the CP, please refer to
Table 5-4 Configuration of CP 340/ 341/ 441-2.
Sending and Receiving SMS Messages with MD720-3
V 2.1, ID Number: 25545680