Advertisement
CONNECTING YOUR 1/4" MIDI DEVICES TO CONDUIT
Connect a power supply (not included) that provides 9V DC
1
center-negative power and at least 50mA of current to the 2.1mm
9VDC power input.
When Conduit powers up, the LEDs will light up to show that
2
the device is powered. The color of the four 1/4" OUTPUT LEDs
will show the current I/O configuration. The factory default I/O
configuration for all four 1/4" TRS jacks is NORMAL mode
- Tip send). This is the configuration used by Strymon pedals.
Go to
strymon.net/support/conduit
output configuration for non-Strymon pedals.
3
Connect a 5-pin DIN MIDI cable from the MIDI OUT port of your
MIDI controller or MIDI interface into the MIDI IN port on Conduit.
Connect one of the included 1/4" TRS cables to one of the 1/4" I/O
4
jacks on Conduit. Connect the other end to the 1/4" MIDI control
input on your pedal. On compatible Strymon pedals, connect to the
EXP or MIDI jack set to MIDI mode.*
(GREEN
for details on changing the
TRS 1/4" CABLE
5-PIN DIN MIDI CABLE
MIDI CONTROLLER
5
Set the MIDI Channel that your pedal will be communicating on.
The default MIDI Channel on Strymon pedals is Channel 1.*
6
Set the MIDI OUT mode on the pedal. If you are only sending
MIDI data to the pedal without sending anything back out from
the pedal, set the MIDI OUT of the pedal mode to OFF.
If you would like to echo the MIDI data received from the
pedals connected to the 1/4" jacks, set the MIDI OUT mode to
THROUGH.*
Sending MIDI messages from your MIDI controller or interface
to Conduit will now distribute these messages to devices
connected to the 1/4" TRS jacks and 5 pin DIN MIDI OUT port.
All MIDI data received at the 1/4" jacks from the pedals are
merged and sent to the 5 pin DIN MIDI port.
* Go to
strymon.net/support/conduit
for more details on configuring your
Strymon pedals to communicate via MIDI. For third party 1/4" MIDI
capable pedals, please see the user manual for the device.
Advertisement
