Advertisement
WELCOME TO CONDUIT
GETTING STARTED
Conduit is a premium, easily configurable,
ultra-reliable MIDI interface that will work
with most 1/4" MIDI equipped effects pedals.
It also offers the best USB computer
connection available for TRS MIDI pedals.
CONTROLS AND CONNECTIONS
ACTIVITY LEDs
Activity LEDs will blink
GREEN
when MIDI information is present at a 1/4" jack.
POWER
Use an adapter with the following rating: 9VDC center negative, 50mA
minimum. Power supply is not required when connected via USB.
STATUS LED for 5-pin DIN I/O
Status LED lights up
GREEN
to indicate Conduit is powered on and will
flash
AMBER
when MIDI data is passing through Conduit to the 1/4" jacks.
1/4" TRS MIDI I/O Jacks 1-4
Out of the box, Conduit's 1/4" TRS MIDI jacks are configured to work with
Strymon pedals, with no further setup necessary. Each jack is capable
of sending and receiving MIDI data, and can be configured to work with a
variety of different 1/4" MIDI communication modes. You can find out which
configuration will work with your specific pedals by visiting
support/conduit.
SMART MIDI DISTRIBUTION
Each of Conduit's four bi-directional 1/4" TRS jacks are
independently configurable to work with a variety of 1/4" MIDI
communication modes. Enjoy easy configuration with no DIP
switches, custom cables, or screwdriver required. Built-in ground
isolation ensures the quiet operation you expect from Strymon.
Link multiple Conduits to control additional 1/4" MIDI pedals.
strymon.net/
USB INTERFACE FOR YOUR PEDALS
Send MIDI control change messages from a sequencer to
perfectly sync pedal parameter changes, automate pedal
preset changes, load and save presets, or send SysEx
messages—all from your computer.
USB-C
Used for computer connectivity. See the Using
Conduit with a Computer section.
SET BUTTON
Used for TRS MIDI I/O Jack configuration.
The SET button can be pressed at any time to
show configuration state of 1/4" TRS jacks.
DIN MIDI I/O Jacks
MIDI IN receives MIDI data from an external MIDI
controller and sends the data to all four 1/4" jacks.
All MIDI data sent back from 1/4" TRS connected
pedals is merged and sent to the MIDI OUT.
When USB is connected, MIDI data received at the
1/4" jacks from the connected pedals is no longer
merged to the MIDI OUT port, but is instead sent to
the connected computer via it's own MIDI port.
Advertisement
