Labeling Diagram - Vestil CYL-H-4-KD Assembly And Maintenance Manual

Table of Contents
• Remove rust and reseal if necessary;
• Check for deformation, for example bending, warping, or cracking;
iii) Inspect the cylinder supports:
• Remove rust and reseal if necessary;
• Check for deformation (bending, warping, or cracking).
iv) Inspect the labeling. Replace labels that are damaged, missing, or not easily readable.

LABELING DIAGRAM

The unit should be labeled as shown in the diagrams. However, label content and location are subject to
change so your product might not be labeled exactly as shown. Thoroughly photograph the unit when you first
receive it as discussed in the
on p. 7-8. Make sure that your record includes a photograph of each label. Replace all labels that are, or later
become, damaged, missing, or not easily readable (e.g. faded). To order replacement labels, contact the
technical service and parts department online at http://www.vestilmfg.com/parts_info.htm. Alternatively, you may
request replacement parts and/or service by calling (260) 665-7586 and asking the operator to connect you to the
Parts Department.
B
A
C
Table of Contents
Rev. 8/21/2019
Record of Satisfactory Condition
Copyright 2019 Vestil Manufacturing Co.
portion of the Inspections and Maintenance
A: All units
Label 287: Model & capacity
(Applied to inside of door)
B: Units used within USA
Label 735: FLAMMABLE – NO SMOKING
(Applied to fronts of both doors)
Units used in Canada
Both Label 735 (above) & Label 736 (below):
(Applied to fronts of both doors)
C: Label 204: Secure frame to floor
(Apply to each side panel of each cabinet)
CYL-H-16-KD MANUAL
section
Page 8 of 9