Exploded View & Bill Of Materials: Attaching Adjacent Cyl-H-8-Kd Units - Vestil CYL-H-4-KD Assembly And Maintenance Manual

Table of Contents
Exploded View and Bill of Materials: Attaching Adjacent 8-Cylinder Units
31-006-165
ASSEMBLY
Sixteen (16) cylinder storage cabinets are comprised of two (2) 8-cylinder cabinets fastened together. The
following instructions sometimes depict only 1 cabinet. However, both cabinets should be assembled as
described and illustrated.
[NOTE: Numbers in parentheses correspond to part numbers in the
Step 1 – Fasten the back panel (31-014-358)
to the side panels (34-514-226) with
5
/ in. hardware
16
36104). The back panel attaches to
the outside of the side panels.
a. Notice that one side of the back panel
has only 2 bolt holes (there are three in
each of the other sides). This is the
bottom side of the back panel.
b. Also notice that each side panel has an
edge with 2 "hinge slots" cut out of it.
This is the front edge of a side panel.
5
c. Insert a / in. – 18 x
16
through the middle and bottom holes in
the back panel and the side panel as
shown in the diagram to the right.
d. Fasten the back panel to the other side
panel in the same manner. Do not
tighten the bolts and nuts at this time.
Table of Contents
Item Part no.
1 31-001-163
2 11205
3 33012
4
36109
(11053; 33006; and
3
/ in. bolt (11053)
4
Copyright 2019 Vestil Manufacturing Co.
Rev. 8/21/2019
Description
CYL-H-8-KD assembly (Exploded View on p. 4)
Hex bolt, grade A, zinc plated,
Flat washer, low carbon, zinc finish,
Hex nut, grade A, plain finish,
exploded view
Back
panel
CYL-H-16-KD MANUAL
NOTE: Adjacent 8-cylinder
units are fastened together to
provide 16-cylinder storage
capacity. The diagram and bill
of materials (below) identify
the hardware necessary to
attach adjacent units.
1
/ " – 13 x 1"
2
1
/ "
2
1
/ " - 13
2
on p. 3.]
Side panel
LS
RB
RS
Side
panel
Page 4 of 9
Qty.
2
4
4
4
Hinge
slots in
front
edges of
side
panels