Bosch AE20 Installation Manual

Install the AE20 using the three-point configuration. The surface mount and octagonal box
installs are the only opyions in the three-point install. Refer to the following illustration.
Install the cover tamper screw. Refer to illustration below.
3 | Specifications
Dimensions (HxWxD) 5 in x 6 in x 1.5 in (12 cm x 16 cm x 4 cm)
NOTICE!
Refer to the control panel or module installtion instructions for connecting to the
control panel.
CAUTION!
All modules used with this enclosure should be power limited. The total
power within the enclosure should be no more that 15 W.
For documentation in your specific language, go to your regional Bosch Security website.
Copyright
This document is the intellectual property of Bosch Security Systems, Inc. and is protected by copyright. All rights reserved.
Trademarks
All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly.
Bosch Security Systems, Inc. product manufacturing dates
Use the serial number located on the product label and refer to the Bosch Security Systems, Inc. website at
http://www.boschsecurity.com/datecodes/.
Reading Bosch Security Systems, Inc. Product Date Codes
For Product Date Code information, refer to the Bosch Security Systems, Inc. Web site at: http://www.boschsecurity.com/datecodes/.
© 2019 Bosch Security Systems B.V, Torenallee 49 5617 BA Eindhoven, Netherlands
Universal Enclosure
AE20
en Installation Guide
Bosch Security Systems, B.V.
Torenallee 49
5617 BA Eindhoven
Netherlands
www.boschsecurity.com