Ribimex RIBILAND PRMPP043 Original Instructions Manual page 25

Assemble the outtake hose joint and the delivery hose (discharge hose) to the water pump.
1. Insert the couplings into the suction and discharge
hoses
2. Use the clamps and tape (not supplied) and tighten
firmly.
Then screw the hose couplings to the pump suction
inlet and discharge port.
3. Screw assembly to pump inlet (4) for suction hose
and pump outlet (3) for discharge hose.
4. Insert strainer in suction hose.
Note: Make sure the washer is properly fitted on the intake hose coupling.
If the washer of the suction hose is loosened, or the hose buckle is lost or damaged, the
water will not be pumped properly due to air leakage.
4.3- Before starting engine
Note: Check that both suction hose and discharge hose are properly assembled.
Note: Before each use, ensure that the fuel tank is fully filled in. Refill if necessary
1. Fill water into the self-priming port to make the intake hose and the water pump full of water.
IMPORTANT: A continual idling or operation without water in the pump will lead to its damage.
So before starting the engine, please make sure that the pump has been refilled water.
If the suction hose strainer appears above the water during the operation, stop the engine as
soon as possible.
2. Make sure that the joint of the suction hose is tightened. Otherwise the air leakage will lead to no
suction or have effect on the power of the pump.
3. Do not install a valve or tap on the discharge hose.
If you proceed with such installation to control the water flow, then never turn off the valve or tap
during operation
4. Water will not be pumped if the discharged hose is obstructed, the sudden great pressure created
inside the pump may damage the pump.
5. If the pump is installed in a location where the discharge hose is likely to be stepped on or pressed,
please ensure to cover it with suitable protective covering.
6. Be sure to install the attached filter (strainer) at the head of the suction hose when it is in use.
7. Set the suction hose filter (strainer) under the water, but never allow it to touch the mud or sand.
8. Before use, please check whether each part is loosened or there is any petrol dripping in the fuel
tank.
9. Before starting the engine, make sure that there is no object that can get wet near the pump.
Remind all bystanders around it that the machine will start working
- 22 -