CITROEN C3 Picasso 2011 Owner's Handbook Manual page 159

Table of Contents

Advertisement

ENERGY ECONOMY MODE
System which manages the period of
use of certain functions to conserve a
suffi cient level of charge in the battery.
After the engine has stopped, you can
still use functions such as the audio
equipment, windscreen wipers, dipped
beam headlamps, courtesy lamps, etc.
for a maximum combined period of
thirty minutes.
This period may be greatly reduced if
the battery is not fully charged.
Switching to economy mode
Once this period has elapsed, a mes-
sage
appears
on
the
screen indicating that the vehicle has
switched to economy mode and the
active functions are put on standby.
If the telephone is being used
at the same time on the MyWay
audio navigation system, it will
be interrupted after 10 minutes.
P R A C T I C A L I N F O R M A T I O N
Exiting economy mode
These functions are reactivated auto-
matically the next time the vehicle is
driven.
In order to resume the use of these
functions immediately, start the en-
gine and let it run for a few minutes.
The time available to you will then be dou-
ble the period for which the engine is left
running. However, this period will always
be between fi ve and thirty minutes.
A fl at battery prevents the en-
multifunction
gine from starting (refer to the
corresponding paragraph).
CHANGING A FRONT OR REAR
WIPER BLADE
Procedure for replacing a worn wiper
blade with a new one without the use
of tools.
Before removing a front wiper blade
Within one minute after switching off
the ignition, operate the wiper stalk
to position the wiper blades in the
vertical position.
This position must be used in order to
avoid damaging the wiper blade and the
bonnet.
Removal
Raise the corresponding wiper arm.
Unclip the wiper blade and remove it.
Fitting
At the front, check the size of the
wiper blade as the shorter blade is
fi tted to the passenger side of the
vehicle.
Put the corresponding new wiper
blade in place and clip it.
Fold down the wiper arm carefully.
After fitting a front wiper blade
Switch on the ignition.
Operate the wiper stalk again to
park the wiper blades.
11
157

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents