QuickStart Guide
CasaTunes CT-8 Music Server
Use this guide to quickly setup and configure your
CasaTunes music server by following these steps:
1.
Unpack and verify system contents
2.
Connect the music server power, network,
control and audio cables
3.
Use the CasaSetup browser application to
configure your system
Use this guide in conjunction with the QuickStart
Guide for your matrix amplifier to setup your
system
Music Server connections
1
Connect the network cable
If your matrix amplifier is controlled using
RS-232 (serial), then connect the 9-pin
2
serial cable from your music server to the
control port on your matrix amplifier
Connect analog 3.5 mm to RCA audio
3
cables from streams 1-3 to your matrix
amplifier
Connect analog streams 4-7 to your matrix
4
amplifier
If you are using Stream 8 (Digital Output)
5
you will need to provide your own cable
6
Connect the power cable
Now follow the QuickStart Guide for your
7
matrix amplifier to connect your music
server with your matrix amplifier
Need Help? Email: Support@CasaTunes.com or Phone: 970.237.3140
What's in the box?
1 x CT-8 CasaTunes music server
1 x Power cable
1 x Network cable
1 x 9-pin Male/Female Serial cable*
7 x 3.5 mm stereo to RCA audio cables
1 x Rack mount kit
4 x Anti-vibration bottom rubber feet
*Replaced with an extra network cable when server is
shipped with a CT-5X4MA or CT-12X8MA matrix amplifier
1
Need help?
Do you have a question about the CT-8 and is the answer not in the manual?
Questions and answers