Advertisement
1. Decorative light
2. Engine RPM
3. Speed
4. Speed unit (KM/H, MPH)
5. Multi-functional area 1 ： Engine RPM, voltage, single driving distance
(KM,Mile), single driving time (Minutes), water temperature
6. Unit for multi-functional area 1
7. Multi-functional area 2: fuel consumption, single driving distance
(KM,Mile)
8. Unit for multi-functional area 2
9. Icon: setting, over speed alarm, fault code, light sensor, fatigue alarm,
shifting reminding, water temperature alarm, low voltage alarm, buzzer
mark
WHEN THE DIAL ON THE LEFT
1. Short pull up (when HUD is power on): Switch for instantaneous fuel
consumption, fuel consumption for 100km, single driving distance (pls.
note, after entering the setting menu, short pull up to increase the
parameter)
2. Short pull down (when HUD is power on): after entering the setting
menu, short pull down to decrease the parameter)
3. Vertical Short press (when HUD is power on): switch for engine RPM,
water temperature, single driving distance and time (pls note: after
entering the setting menu, vertical short press to increase the menu)
4. Long pull down: turns on or o the alarm sound.
5. Vertical long Press in 5 seconds: enter into setting menu, after the
adjustment, vertical long press in 5 seconds to save it and exit.
6. Long pull up: Pull up the wave button 5 seconds to clear the engine
fault code when HUD in normal state.
BUZZER ICON:
Pull down: pull down the wave button 5 seconds to turn o the buzzer,
another 5 seconds to turn on the buzzer.
CLEARING ENGINE FAULT CODES:
Pull up the wave button 5 seconds to clear the engine fault code when
HUD in normal state
RESET SETTING:
Long press in for 5 sec. to enter the setting menu, short press 14 times to
nd menu 14, adjust the default value from 0 to 1, then press for 5 sec. to
keep and exit.
M
2
www.PyleUSA.com
Advertisement
