Table of Contents
Advertisement
Playback connection
The exact arrangement you use to interconnect various video and audio components to the DVD/VCR is dependent
on the model and features of each component. Check the Owner's Manual provided with each component for the
location of SCART socket.
Connection to a Satellite Receiver
If a Satellite Receiver is used, we recommend the following configuration:
Satellite
Antenna
DVD/VCR
Satellite
Receiver
SCART-cable (not
supplied)
SCART-cable (not supplied)
To record from Satellite Receiver press AUX on the remote control of DVD/VCR. "L1" will appear on the front
display. Select the desired TV-program at Satellite Receiver.
Connection to a Decoder (for Premiere Programs)
SCART-cable (not supplied)
DVD/VCR
SCART-cable (not supplied)
Note: Make sure that AV - mode in SYSTEM SETUP - menu has been set
to DEC .
If you set to [AV], the output signal from the decoder will be seen on the TV
while the DVD/VCR is turned off.
12
Setting the TV to the RF-Channel
We recommend that television and DVD/VCR are being connected with a scart cable.
In this case, the setting of RF-channel is not necessary. Picture and sound of video cassette will be transmitted to
television through the scart cable automatically. Please read the next page.
Preparation
In case of no scart cable connection,
• Turn on the TV.
you must set the television to the RF-
• Press VCR to select the VCR mode.
channel. Pay attention to the following
• Make sure the power of DVD/VCR has been turned off.
notice:
A built-in modulator in DVD/VCR can
1
Press ON/STANDBY on the DVD/VCR and hold it until the
output the VCR playback through the
display shows rF:. The number next to rF: is the channel in
RF out jack. This output is sent on UHF,
UHF-band to which you must tune your TV-set.
channel 60. To receive this broadcast,
you must tune your television to chan-
nel 60 in UHF-band. (see step 2)
In case a broadcast is already at chan-
nel 60 in your area or you connect an
2
additional equipment (e.g. Satellite re-
Switch your television to the program position on which the
ceiver) with a coaxial cable (without a
video playback is seen. Start the channel search of your
scart cable), you must change the RF
television until "TEST" appears. Store this tuning in televi-
out channel in DVD/VCR to another
sion like the case of the reception for normal television-
channel (see step 3). In your television
channels you would store.
store the RF out channel of the DVD/
VCR at another channel position.
If you want to use your DVD/VCR,
switch your television to this program
Example: Your satellite receiver is sent
position.
to channel 60. You tune the DVD/VCR
to channel 64 (see step 3).
(If your DVD/VCR is also sent to chan-
3
If there is interference in the picture (you see 2 programs
nel 60, interference will occur.)
simultaneously or what is called Ghosts), change the send-
In your television store the channel 60
to e.g. program position 3 and store the
ing channel in DVD/VCR. To do this, go back to the step 1.
Use CHANNEL button on the DVD/VCR to change the
channel 64 to e.g. program position 4.
number next to the rF:. Then return to step 2 and tune the
Note that the program position 4 will
be used specially for video-playback.
television newly.
Please see the owner's manual for your
television. If the playback picture is of-
4
Press ON/STANDBY on the DVD/VCR to turn off the
ten distorted, you must select another
DVD/VCR.
program position for DVD/VCR.
6-56
Note:
If you receive one TV-program on channel 59, 60 or 61, the interference can be occurred to the built-in TV channel
in DVD/VCR. If you use a scart cable for the transmission of picture and sound, you can cut off the built-in TV-
program. Then the video playback through the supplied antenna cable is not possible any more. Press CHANNEL
repeatedly (at step 1) until OFF will appear.(OFF appears after 69 or before 23)
14
TV
TV-unit
Cable TV-
Decoder
connection
RF-Output
SYSTEM SETUP
CLOCK SET
LANGUAGE/üáúIK
AV2
[DEC]
RF OUT
[K]
SELECT :
/
ENTER : ENTER
EXIT
:
MENU
VCR
TEST
1,4
3
Component video outputs/inputs
PROGRESSIVE outputs/inputs
Some TVs or monitors are equipped with component video inputs that are capable of reproducing a progressively scanned
video signal. Connecting to these inputs allows you to view the highest quality pictures with less flicker.
INTERLACED outputs/inputs
Some TVs or monitors are equipped with component video inputs. Connecting to these inputs allows you to enjoy the highest
quality DVD picture playback.
Connecting to an audio system and TV equipped with component video inputs
Component video cable (not supplied)
Component (Y) Output
Component (P
) Output
B
DVD/VCR
Component (P
) Output
R
Stereo Amplifier
Audio (L) Output
Audio (R) Output
AUDIO Cord (supplied)
• Make the following setting
On-screen
display
See Output selection (P.58).
TV
Interlaced inputs
Component
Progressive inputs
Progressive
Notes:
• Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, CB, CR)
• In some TVs or monitors, the colour levels of the playback picture may be reduced slightly or the tint may change. In such a
case, adjust the TV or monitor for optimum performance.
Note:
In connecting to a TV that are not capable of reproducing a progressively scanned video signal using the component
sockets, do not select "Progressive" in "Output" menu. If you do it, the component video outputs does not feed the
correct signals and you can not see any picture (see page 58).
Connect to an AV Amplifier with built-in digital surround
If you are using an Amplifier with a built-in digital surround as follows, you can enjoy the various audio systems such as Dolby
Digital and DTS by using the Coaxial Digital Output or Optical Digital Output.
Use this connection to connect an:
• AV amplifier with built-in *Dolby Digital decoder
• AV amplifier with built-in *DTS decoder
Optical cable (not supplied)
*
Connect either
*
Coaxial digital cable (not supplied)
*
DVD/VCR
Coaxial digital Audio Output
SCART-Socket
SCART-cable (not supplied)
(for TV-RGB/Composite)
Notes:
• The Optical or COAXIAL/OPTICAL jack is useful only for DVD section.
• DTS audio will be output only from the OPTICAL or COAXIAL output. To hear DTS audio, DTS-Decoder is necessary.
When playing DTS-encoded CDs, only noise will be heard from the speakers or analogue stereo outputs.
• Some DTS decoders which do not support DVD-DTS interface may not work properly with the unit.
Setting the On-screen language
Turn on your TV and select the AV-
Preparation:
Program position, on which you have
• Press the
already set for your DVD/VCR. (it will
• Press VCR to select the VCR mode. (The VCR indicator will light.)
happen automatically by Scart-cable
connection). So you can follow the
You can choose from two different languages (English or Rus-
setting on TV screen.
sian) for the on-screen displays.
1
Press VCR MENU. Press
to select the "ìCTAHOBKA
CàCTEMõ" menu, then press
ENTER.
If you use the unit for the first
time and press VCR MENU, in-
stead of the main menu screen
on the right the "LANGUAGE"
set up menu screen in step 3
may appear.
2
Press
"LANGUAGE" option, then press
ENTER.
3
Press
desired language: English or
Russian (êìëëäàâ), then
press ENTER.
4
Press VCR MENU repeatedly until the TV picture appears on
the screen.
Notes:
• If the unit does not operate properly,
or No key operation (by the unit and/
or the remote control): Static elec-
tricity, etc., may affect the player's
operation. Disconnect the AC power
cord once, then connect it again.
• If no buttons are pressed for more than
60 seconds, the MENU screen will re-
turn to normal TV-operation automati-
cally.
Playback connection
Component
video input
TV
To Audio (L) Input
To Audio (R) Input
AV Amplifier with
built-in various
decoder as above
TV
To SCART
input
13
button to turn on the DVD/VCR.
or
áÄèàëú èé íÄâåÖêì
ÄÇíé èéÇíéê
Çõäã
ìCTAHOBKA BM
ìCTAHOBKA KAHAãA
ìCTAHOBKA CàCTEMõ
BõÅêATú
:
BBOÑ
: ENTER
BõïOÑ : MENU
or
to select the
ìCTAHOBKA CàCTEMõ
HACTPOâKA óACOB
LANGUAGE/üáúIK
AV2
[AV]
RF OUT
[K]
BõÅêATú
:
BBOÑ
: ENTER
BõïOÑ
: MENU
or
to select the
LANGUAGE/ü3úIK
ENGLISH
PìCCKàâ
SELECT :
OK: ENTER
15
Advertisement
Chapters
Table of Contents
