Toshiba SD-46VSR Service Manual page 43

Main Chassis Ass'y (Bottom Side)
Check Hook
• Loosen the wire in the direction of the arrow.
3-8: FFC WIRE HANDLING
1. When installing the FFC, fold it correctly and install it as
shown from Fig. 3-8-A to Fig. 3-8-C.
NOTE
1. Do not make the folding lines except the specified
positions for the FFC.
[ 24 pin FFC ]
50 ± 1mm
Fold it by 90˚
117 ± 1mm
[ 5 pin FFC ]
(1) Reinforcement Plate
55 ± 1mm
Printing Surface
Fold
Fold
(2)
10 ± 1mm
Printing Surface
• Proceed the steps (1) through (4).
[ 6 pin FFC ]
(1) Reinforcement Plate
53 ± 1mm
Printing Surface
Fold
Fold
(2)
10 ± 1mm
Printing Surface
• Proceed the steps (1) through (4).
DISASSEMBLY INSTRUCTIONS
Check Hook
Check Hook
Check Hook
Fig. 3-7-D
Fold back at the border line
of the reinforcement plate.
73 ± 1mm
Fold 10mm
Double Sided Tape
Fig. 3-8-A
(3)
Reinforcement Plate
10 ± 1mm
Printing Surface
Fold
Reinforcement Plate
(4)
Fold
Printing Surface
60 ± 1mm
Fig. 3-8-B
(3)
Reinforcement Plate
10 ± 1mm
Printing Surface
Fold
Reinforcement Plate
(4)
Fold
Printing Surface
52 ± 1mm
Fig. 3-8-C
B3-4