Installation Procedures - Pentair Everpure Oxidice Installation And Operation Manual

INSTALLATION PROCEDURES

Clean Ice Maker
Clean your ice maker according to industry standards. The
Pentair® Everpure® Oxidice is designed to keep a clean ice maker
from becoming dirty. It will sterilize a dirty ice maker, but it may
still appear dirty.
Unpacking
Make sure all components are in the box before the installation
process. In addition to this manual, you should have (1) Oxidice
system, (1) z-bar mount, (1) 10 ft tube, (1) rubber grommet, and (1)
diffuser.
Find a Mounting Location
Before beginning the installation, locate a suitable location for
the Oxidice system. Find a flat portion of a wall close to the ice
maker. The system may also be placed on a flat, level surface.
Please consider the following when selecting a mounting location:
1. Never install the system in an area where water may freeze.
Freezing water will damage the internal components.
2. Mount horizontally. Do not mount vertically or at an angle.
Always use a level when installing this unit.
3. The system should be close enough to a power outlet, so an
extension cord is not necessary.
4. Mount the system no further than 10 feet from the point of
use and above the entry point of the ozone line into the ice
maker.
Mounting the System
1. Use the appropriate tools and mounting hardware (not
provided) for the existing wall's construction and install the
z-bar. Use a level to make sure it is horizontal.
2. Place the system onto the z-bar.
CONNECT DIFFUSER
1. Drill (1) 9/16-inch hole into the ice maker close to and above
the water reservoir. Install grommet provided into the hole.
2. Attach one end of the supplied tubing to the ozone outlet of
the system.
3. Run tubing through grommet installed in the ice maker.
Attach the opposite end of the tubing to the diffuser' s barbed
fitting, then place the diffuser into the water reservoir.
4 • Pentair® Everpure® Oxidice Installation and Operation Guide