Mode - Ready And Rest; Ready-In-Rest Mode - Canadian Spa BP Series Owner's Manual

O K A N A G A N / S A S K A T O O N / G A N D E R / M U S K O K A S P A S
Mode – Ready and Rest
In order for the spa to heat, a pump needs to circulate water through the heater. The pump that performs this function is
known as the "primary pump."
The primary pump can is a 2-Speed Pump
Primary pump is a 2-Speed Pump 1, Ready Mode (indicated by ) will circulate water periodically, using Pump 1
Low, in order to maintain a constant water temperature, heat as needed, and refresh the temperature display. This is known
as "polling."
Rest Mode (indicated by ) will only allow heating during programmed filter cycles. Since polling does not occur, the
temperature display may not show a current temperature until the primary pump has been running for a minute or two.
In Rest Mode, the spa will only heat to set temperature during programmed filter times, even though the water is being
filtered constantly when in Circulation Mode.

Ready-in-Rest Mode

appears in the display if the spa is in Rest Mode and "Jets" is pressed. It is assumed that the spa is being used and
will heat to set temperature. The primary pump will run until set temperature is reached, or 1 hour has passed. After 1 hour,
the System will revert to Rest Mode. This mode can also be reset by entering the Mode Menu and changing the Mode.
(13)