Toyota CAMRY 2021 Owner's Manual page 134

132
2. Instrument cluster
■
The meters and display illuminate when
Vehicles without a smart entry & start system

The engine switch is in the "ON" position.
Vehicles with a smart entry & start system

The engine switch is in IGNITION ON mode.
■
Brightness of the meters (day mode and night mode)
●
The brightness of the meters is changed between day mode and night
mode.
• Day mode: When the tail lights are off or when the tail lights are on but
the surrounding area is bright
• Night mode: When the tail lights are on and the surrounding area is dark
●
When in night mode, the brightness will be reduced slightly unless the
meters are set to the maximum brightness level.
■
Outside temperature display
In the following situations, the correct outside temperature may not be dis-
played, or the display may take longer than normal to change:
● When stopped, or driving at low speeds (less than 25 km/h [16 mph])
●
When the outside temperature has changed suddenly (at the entrance/exit
of a garage, tunnel, etc.)
●
When "" or "E" is displayed, the system may be malfunctioning.
Take your vehicle to your Toyota dealer.
■
Fuel gauge and driving range display
The fuel gauge and driving range display are linked. If the fuel gauge and
driving range display do not update after refueling a small amount, they can
be updated by performing the following procedure:
Stop the vehicle on a level surface.
1
Wait until the fuel in the fuel tank stabilizes.
Press the ODO/TRIP switch to change the odometer and trip meter display
2
to the odometer.
3 Turn the engine switch off.
Vehicles without a smart entry & start system:
4
While pressing and holding the ODO/TRIP switch, turn the engine switch to
the "ON" position.
Vehicles with a smart entry & start system:
While pressing and holding the ODO/TRIP switch, turn the engine switch to
IGNITION ON mode.
Continue holding the ODO/TRIP switch for approximately 5 seconds.
5
Release the switch when the odometer begins blinking.
Updating will be complete when the odometer blinks for approximately 5
seconds and then returns to the normal display.
CAMRY_GE
CAMRY_OM_General_OM33F01E