Basic Key Use - Agilent Technologies ESA-E Series Measurement Manual

Preparing to Make Bluetooth™ Measurements

Basic Key Use

Basic Key Use
The
additional loaded personalities. When you select a standard, the analyzer will set
measurement parameters to meet the standard requirements. If necessary, change
the global measurement settings in the analyzer based on your system using
Mode Setup
The
specific frequencies. You can do this by either setting absolute frequencies or by
setting the channel number when in the Bluetooth™ mode.
You can select a number of previously-configured standards based measurements
to help you troubleshoot a system using the
measurement situations are different,
some of the measurement parameters. Finally, if you need to quickly start the
measurement again, press
Figure 2-1 Basic Keys
8
MODE key allows you to choose basic Spectrum Analyzer, Bluetooth™, or
.
Channel Frequency or
Restart
RF Channel keys allow you to tune the analyzer to
Measure
allows you to quickly change
Meas Setup
or use Restart under
button. Because all
Meas Control .
Chapter 2