Bissell POWERFORCE COMPACT 2112 Series User Manual page 12

Replacing Drive Belt
WARNING
To reduce the risk of electric shock, turn power switch OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
1
Place vacuum upside down with brush
roll facing upwards. Remove 5 screws
with a Phillips screwdriver.
3
Test the brush roll by
holding on end and
spinning. It should spin
freely several revolutions
from one flick. If not,
the brush roll will need
to be replaced.
5
When finished, align brush roll with
belt turning by hand several times in
the direction of the motor to align the
belt on the brush roll.
12
www.BISSELL.ca
2
Lift off brush cover and grasp brush
roll at both ends to lift out. Check
drive belt carefully for wear, cuts and
stressed areas. If the drive belt
appears worn, replace as needed.
4
Grasp old drive
belt and remove
from motor shaft to
discard. Loop new
drive belt over motor
shaft and stretch
other end over brush
roll in the space
provided between the
bristles.
6
Replace the brush cover and 5 screws.