Electrolux EW8F8669Q9 User Manual page 38

38 www.electrolux.com
The drain pump can operate
shortly before the appliance
fills water.
12.6 Starting a programme with
the delay start
1. Touch the Delay Start
repeatedly until the display shows the
desired delay time. On the display the
indicator shows
2. Touch the Start/Pause
appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Delay Start
repeatedly until the display shows the
desired delay time. On the display
the indicator shows
Touch the Start/Pause
appliance lock the door and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
2. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
3. Touch the Delay Start
repeatedly until the display shows
and the indicator
4. Touch the Start/Pause
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
button
button. The
.
button
button. The
.
button to
button
goes off.
button
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause
again to start the new countdown.
12.7 The SensiCare System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pause
button, the maximum declared load
indicator goes off, the SensiCare System
starts the laundry load detection:
1. The appliance detects the load in the
first 30 seconds. In the programmes
where Time Manager is available,
during this phase the Time Manager
bars placed below the time
digits play a simple animation. The
drum rotates shortly.
2. The programme duration could be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display: in this case, for 30
seconds, it is possible to pause the
appliance and remove the exceeding
garments.
Once removed the exceeding garments,
touch the Start/Pause
the programme again. The SensiCare
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
button to
button
button
is
button to start