Table of Contents
Advertisement
http://202.224.189.179/view_new/OT/KX-TCD725RUM/SVC/s0804000000.html
18. Press Menu Up "↑" on the CMD60.
19. Press BER.
20. Obtain the sensitivity by slowly reducing RF LEVEL until the BER falls below 1000ppm. The
sensitivity is the RF LEVEL reading at this point. It must be < -88dBm.
21. Press Menu Up "↑" on the CMD60.
22. Press BEARER RELEASE and switch off the 9V supply.
23. Disconnect the RF cable from the PCB.
Note:
These tests can also be repeated on TRAFFIC CARRIERS 5 and 9.
TOP PREVIOUS NEXT
http://202.224.189.179/view_new/OT/KX-TCD725RUM/SVC/s0804000000.html (2 of 2)13.10.2007 10:18:35
Advertisement
Table of Contents
