Table of Contents
Advertisement
http://202.224.189.179/view_new/OT/KX-TCD725RUM/SVC/s1502000000.html
15.2 Introduction
TOP PREVIOUS NEXT
The base unit uses a 32k bit (4096 x 8) serial EEPROM (IC9) for storing volatile parameters. All
parameters are set up before the base leaves the factory. Some of these are vital for the operation of the
hardware so a set ofdefault parameters is programmed before the actual hardware fine-tuning can be
initiated. This document lists all default settings with a short description.
In the tables below values in a range that are similar are not repeated; i.e. Address 00 to 01 contains the
value 00 simply means that the value 00 is repeated in all addresses in the range. All values in this
document are in hexadecimal notation.
Type
Name Description
D
default The EEPROM location is preset to the Default value by the eeprom default loader.
A
adjust The EEPROM location is set during the production test and should not be overwritten. The value is set by the eeprom
default loader only if the location contains all 1's (byte: 0xFF, word FFFFh), i, e.it has never been set.
-
EEPROM location which is not set at all.
d
default Same as D but best-guess value and/or not verified.
TOP PREVIOUS NEXT
http://202.224.189.179/view_new/OT/KX-TCD725RUM/SVC/s1502000000.html13.10.2007 10:21:22
Advertisement
Table of Contents
