GE PHS93X Owner's Manual page 31

Cleaning the Glass Cooktop (Cont.)
Precision Cooktop Sensor
1. Allow cooktop to cool.
2. Apply soapy water to a non-abrasive sponge and
spread across any residue on the sensor.
pressure as needed
4. If any residue remains, repeat the steps listed above
as needed.
5. Wipe the sensor with a wet towel or sponge to remove
any soap.
6. Dry the sensor after cleaning using dry towel.
Metal Marks and Scratches
1. Be careful not to slide pots and pans across
your cooktop. It will leave metal markings on the
cooktop surface.
These marks are removable using the ceramic
cooktop cleaner with the non-scratch cleaning pad for
Ceramic Cooktops.
Damage from Sugary Spills and Melted Plastic
Special care should be taken when removing hot substances to avoid permanent damage of the glass surface.
Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your
cooktop (not covered by the warranty) unless the spill is removed while still hot. Special care should be taken when
removing hot substances.
Be sure to use a new, sharp razor scraper.
Do not use a dull or nicked blade.
1. Turn off all surface units. Remove hot pans.
2. Wearing an oven mitt:
the spill to a cool area on the cooktop.
b. Remove the spill with paper towels.
49-2000876 Rev. 0
IMPORTANT: Make sure sensor is dry before cooking.
If sensor is not clean and dry cooking performance could
be affected. Do not use cream based cleaners, abrasive
pads or razor blades on sensor surfaces.
2. If pots with a thin overlay of aluminum or copper
are allowed to boil dry, the overlay may leave black
discoloration on the cooktop.
This should be removed immediately before heating
again or the discoloration may be permanent.
NOTE: Carefully check the bottom of pans for roughness
that would scratch the cooktop.
3. Any remaining spillover should be left until the surface
of the cooktop has cooled.
4. Don't use the surface units again until all of the
residue has been completely removed.
NOTE: If pitting or indentation in the glass surface has
already occurred, the cooktop glass will have to be
replaced. In this case, service will be necessary.
31