With The Ft-70Dr/De); Get Data From Ft-70D; Send Data To Ft-70D - Yaesu FT-70DR Instruction Manual

Communications (Data communication with the FT-70DR/DE)

• Get Data from FT-70D

This command transfers the settings data of the FT-70DR/DE to the ADMS-10 programmer. To commu-
nicate with the FT2DR/DE and create a new data file. Click the left mouse button on the "Get Data from
FT-70D" parameter in the "Communications" menu. The "Get Data From FT-70D" window will open. Con-
nect the supplied USB cable between the FT-70DR/DE and the computer.
Follow the on-screen instructions to acquire data from the FT-70DR/DE. When the data transfer is com-
pleted, the template screen received from the FT-70DR/DE appears on the computer display.
The memory channels and configuration menu data may be edited using the ADMS-10 software tools.
This template and configuration data may be saved to the computer hard drive, using the
"Save" or "Save as" commands in the "File" menu.

• Send Data to FT-70D

This command downloads the ADMS-10 data from the computer to the FT-70DR/DE
Click the left mouse button on the "Save Data to FT-70DR/DE" parameter in the "Communications"
menu. The transmission procedure screen will open.
To load a previously created data file to the FT2DR/DE, click the "Open" parameter in the "File"
menu, and open the desired file before performing the send data operation above.
Connect the supplied USB cable between the FT-70DR/DE and the computer.
Follow the on-screen instructions to transmit data to the FT-70DR/DE. After the data transmission com-
pletes, "Completed" will appear on the computer display, and click the [Close] button. Then, remove the
plug of the USB cable and battery charger (SAD-18B/SAD-11) from the FT-70DE/DE, after installation of
the battery pack, the FT-70DR/DE will automatically start up in accordance with the set data.
• Never disconnect the programming cable while data transmission is in progress.
• Pay careful attention to the power cable and the connections to the FT-70DR/DE and the
computer, so as not to lose the power during data reception/transmission.
ADMS - 10 Instruction Manual
17