Shipping Of The Diaphragm Type Accumulator; Storage Of The Diaphragm Type Accumulator - Bosch Rexroth HAD 1 Series Operating Instructions Manual

Diaphragm type accumulator
Table of Contents

Advertisement

Requirements
Maximum storage time
Commissioning after storage

6.2 Shipping of the diaphragm type accumulator

The diaphragm type accumulator may only be shipped alone or installed in a machine
or assembly and securely
If the diaphragm type accumulator is shipped with a preload pressure of 2 bar and
more, it must be declared as UN number 3164 (Article under pneumatic pressure
containing non-flammable gas). Depending on the type of dispatch, the relevant
directives must be observed. Diaphragm type accumulators are only shipped
depressurized for air freight ex works. Any existing pre-filling pressures will be
released.

6.3 Storage of the diaphragm type accumulator

The diaphragm type accumulator is supplied with a coating. The machine end-user
must ensure sufficient corrosion protection during storage.
• Ensure that the storage facilities are free from etching substances and gases.
• Optimum storage temperature: +5 °C to +20 °C. Ensure a constant temperature,
if possible.
• The storage facilities must be dry.
• Protect the diaphragm type accumulator against impacts during storage.
• Ensure that the cover cap at the gas valve and the protective cap at the oil valve are
attached.
The maximum storage time of the diaphragm type accumulator amounts to 5 years.
Carry out a visual inspection of the diaphragm type accumulator and check for
any damage and corrosion.
After the expiration of the maximum storage time, have the complete diaphragm
type accumulator checked by an expert, see chapter 2.4 "Qualification of
personnel".
Please note that the warranty period is not prolonged by the storage time.
The claim to warranty expires in case of non-compliance with the requirements
and the storage conditions or after expiry of the maximum storage time.
Please note that, according to the provisions and ordinances valid in your
country, the test intervals mostly refer to the date of manufacture and are also
not prolonged by the storage time.
fastened.
Type HAD...-1X/ and HAD...-2X/, RE 50150-B/10.20, Bosch Rexroth AG
Transport and storage
21/44

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rexroth had 2 seriesHad2,8-250-20

Table of Contents