Table of Contents
Advertisement
ASSEMBLY
Canopy
Attaching the Canopy:
On both sides of the seat you will find a rectangular, grooved mount. Slide
the canopy ratchet onto one of these side mounts (from the top to the
bottom). Make sure to push enough to get the ratchet to be placed fully on
the mount. (You will feel a positive click, when this has been completed)
Repeat on the other side. (pic1) (pic2)
Feed the recline lever through the hole in the back of the canopy. (pic3)
On the back lip of the canopy you will find 6 snaps that correspond to 6
snaps on the seat. These need to be attached. (pic4) (pic5)
On both sides of the stroller seat you will find a snap that corresponds to
a snap on the canopy, these need to be attached(pic6)
Removing the Canopy (pic7)
Pull the tab. (A)
Lift the ratchet off the mount. (B)
Unsnap the buttons. (C)
A
B
10
USING YOUR STROLLER
Seat
Removing the set
To remove the seat from the stroller chassis, lift the release lever at the top of
the seat, then push the seat forward until the backrest is past 90 degrees. Lift
the seat off the chassis.
Attaching the seat
To attach the seat, line up the seat grooves above the chassis slots (both
sides of the seat) and lower the seat down onto the chassis.
Note: The stroller seat will fit in either the forward or reversed direction.
C
11
Advertisement
Table of Contents
