Unused Plugs; Power Supply; First Steps - Wachendorff OPUS A6 ECO 2 Operating Manual

The ECU must be the component in charge of all safety related
functions.
Please keep all the connectors separated. All connection should be done on the
shortest distance to the unit.
Wrong connection may cause damage of the unit.

4.3.1 Unused plugs

ACH
Penetrating humidity by unused and unprotected plugs may
cause damage of the unit. Please protect unused plugs with the
special blind inserts that have been supplied with the units.
TUN

4.3.2 Power Supply

The unit may be used with the 12 V and for 24 Volt battery systems, operating
voltage range of 9-36 VDC. The overvoltage resistance is about 48V for 2 minutes.
Inverse-polarity protection is up to -48 V DC.

4.4 First steps

Plug in the main connector into the OPUS A6 2
clamps 15 and 30 for the plus voltage, as well as clamps for GND and CarGND for
the ground. Switch on the Power supply.
On start the boot-logo image will be displayed on the screen. This may be
exchanged with the customer specific image (please refer to C/C++ Developer
Guide for more information).
The boot up takes about 3 minutes and will call the application according to the start
scripts on the unit (start scripts for Projektor Tool and CoDeSys application already
installed by delivery).
The application displays the information of the required application software version.
CoDeSys application also contains a simple function test. Each newly downloaded
application will replace the old one automatically.
Technical Documentation
nd
generation. Then connect the
Seite 23 von 31