Technical Specifications - E-Mu PM5 Manual

DON Analog Localized.book Page 5 Monday, September 5, 2005 11:48 AM

Technical Specifications

General
Type
Frequency Response
Maximum Sound Pressure Level, short term Single: ≥100dB SPL @1m
Drivers
Dimensions
Weight
Power
Crossover Network
Type
Inputs
Input sensitivity control range
Input impedance
Crossover frequency
Amplifiers
Type
High Frequency Amplifier
Low Frequency Amplifier
Fuse ratings
Two-way, bi-amplified near-field reference monitor
67Hz - 20kHz (±2.5dB)
Pair: ≥103dB SPL @1m
High Frequency: Type: Neodymium Soft Dome
Size: 25.4mm (1")
Low-Frequency: Type: Glass Fiber Cone
Size: 127mm (5")
Height: 290mm (11.5")
Width: 175mm (6.9")
Depth: 245mm (9.7")
6.5kg (14.3lbs)
120V, 60Hz or 220 V-240 Vca 50/60 Hz, depending on the region of purchase
Active second-order Butterworth
Input 1: XLR female balanced
Input 2: ¼" Jack socket balanced
Input 3: RCA unbalanced
-21 dB to 0dB
Balanced: 47K ohms
Unbalanced: 47K ohms
2.5kHz
Custom discrete with Class-A input stage and MOSFET output stages
Power: 40W RMS into 4 ohms
Signal-to-Noise Ratio, referred to full output: > 98dB
Distortion: THD < 0.2%
Power: 40W RMS into 4 ohms
Signal-to-Noise Ratio, referred to full output: > 98dB
Distortion: THD < 0.2%
120Vac 60Hz model: T1AL. 250Vac.
T1AL (where T = Time lag, Fuse rating 1A and L = low breaking capacity.)
220V-240Vac 50/60Hz model: T500mAL. 250Vac.
T500mAL (where T = Time lag, Fuse rating 500mA and L = low breaking capacity.)
5