Overview - E-Mu PM5 Manual

DON Analog Localized.book Page 2 Monday, September 5, 2005 11:48 AM

Overview

The following section introduces you to the different components on your speaker.
1 2 3 4 5
Connecting Speakers
Your speaker features a combination XLR/TRS balanced analog input connector and an RCA unbalanced analog input connector
for connecting a wide variety of analog audio input devices.
• Before connecting your speaker, make sure that the Input sensitivity control knob
• Do not connect more than one audio input device to your speakers at any one time as this will cause the mixing of input signals
and result in unwanted noise.
You may hear a thump from your speaker when you turn it on and off. Make sure that your speaker is the last device to be turned
on and the first device to be turned off in your audio set up to prevent this from occuring.
Balanced ¼-inch TRS
1
Balanced XLR male
2
Unbalanced RCA
3
After you have connected your audio device to your speaker, make sure that you select the appropriate input connection type
using the Balanced (BAL)/Unbalanced (UNBAL) switch
2
Combination XLR/TRS balanced analog input connector
1
Balance (BAL)/Unbalance (UNBAL) switch
Select either balanced (XLR or TRS) or unbalanced (RCA) analog
2
inputs with this switch.
RCA unbalanced analog input connector
3
6
Input sensitivity control knob
4
Adjusts the input sensitivity of your speaker.
7
Attenuation switches
• Adjust the bass roll off with the LF (Low Frequency) switch
5
• Adjust the treble tilt with the HF (High Frequency) switch
• By default, both switches are set to zero.
Power socket
8
• Disconnect the power adapter cable from the power socket if you
do not intend to use your speaker for several days
6
• Make sure that the voltage rating of your speaker matches the
voltage standard of your country.
ON/OFF switch
7
Power LED
• Lights up in blue when your speaker is turned on
8
• Lights up in red when the overload protection circuitry engages.
1 = Ground/Shield
2 = Hot (+)
3 = Cold (-)
Tip = Hot (+)
Ring = Cold (-)
Sleeve = Ground/Shield
Connector
Connect either to the combination XLR/TRS balanced
analog input connector
Connects to the RCA unbalanced analog input connector
Speaker Components
is turned fully counterclockwise.
2
3
2 1
3
1
Connection
.