Table of Contents
Advertisement
CCS Technical Documentation
4.
Remove screws
The estimated optimal torque for the all six screws is 22 Ncm and the speed of rotation
480 rpm. The unscrewing order for pre-production is in the reverse order to screwing;
55, 54, 53, 52, 51, and 50. The screwing order possibilities for testing purposes is limited
to six (3!=3x2x1=6).
5.
Remove antenna
Wear gloves or rubber fingertips when handling the antenna.
6.
Remove D-cover assembly
The D-cover is correctly removed when the four side snap joints of the D-cover are
released from the A-cover. Use your fingernails or a screwdriver with a chisel point
between the A and D-covers at the middle of the snap joint area to do the operation.
Note: Screwdriver must not hit the engine module or components on it during disas-
sembly. Be also careful not to scratch covers.
On the next page you can see the removal operations of the subassemblies and parts of
Issue 1 07/02
Assembly & Disassembly Instructions
ãNokia Corporation
NPM-2NX
Page 13
Advertisement
Table of Contents
