Flash Programming Error Codes - Nokia NPM-2NX Troubleshooting Manual

CCS Technical Documentation

Flash programming error codes

Error codes can be seen from "FPS-8 Flash" in Phoenix.
Underlined note means that item under consideration is being used first time in flashing
sequence.
Error Description
C101 "The Phone does not set FbusTx line high after the
startup."
C102 "The Phone does not set FbusTx line low after the
line has been high. The Prommer generates this
error also when the Phone is not connected to the
Prommer."
C103 "Boot serial line fail."
C104 "MCU ID message sending failed in the Phone."
C105 "The Phone has not received Secondary boot codes
length bytes correctly."
C106 "The Phone has not received Secondary code bytes
correctly."
C107 "The Phone MCU can not start Secondary code cor-
rectly."
A204 " The flash manufacturer and device IDs in the
existing Algorithm files do not match with the IDs
received from the target phone."
A387 "The MCU ID in the MCUSW
C601 "The prommer has detected that Vpp voltage level
has dropped below the limit"
C383 "The Prommer has not received Phone acknowledge
C583 to the message."
C683 (C383-during algorithm download to target phone)
(C583-during erasing)
(C683-during programming)
Issue 1 07/02
Table 2: Flash programming error codes
ãNokia Corporation
Troubleshooting
Not working properly
Vbatt
Vflash1
Vcore
VIO
BSI and FbusRX from prommer to UEM.
FbusTx from UPP->UEM->Prommer(SA0)
PURX(also to Safari)
VR3
Rfclock(VCTCXO->Safari->UPP)
Mbus from Prommer->UEM-
>UPP(MbusRx)(SA1)
FbusTx from UPP->UEM->Prommer(SA1)
Mbus from Prommer->UEM-
>UPP(MbusRx)(SA0)
FbusRx from Prommer->UEM->UPP
FbusTx from UPP->UEM->Prommer
FbusTx from UPP->UEM->Prommer
Mbus from Prommer->UEM->UPP(MbusRx)
FbusRx from Prommer->UEM->UPP
FbusTx from UPP->UEM->Prommer
Mbus from Prommer->UEM->UPP(MbusRx)
FbusRx from Prommer->UEM->UPP
FbusTx from UPP->UEM->Prommer
UPP
Flash
Signals between UPP-Flash
UPP
Vpp from prommer - >Flash
Flash
UPP
Signals between UPP-Flash
NPM-2NX
Page 13