Table of Contents
Advertisement
25. Num controller – adjusts the shot number (0 - 16)
26. Slope-CV jack (input) – determines by a control voltage (-5 V - +5 V) the
rising-to-falling time ratio of the triangle
27. Slope controller – set the rising-to-falling time ratio of the triangle
28. 7-Segment Display indicator – visualizes the set shot number and the
current state of an executed shot (down counter)
29. Sync jack (input) – a +5 V trigger set the LFO immediately to the State
(19)
(20)
value
,
30. Rectangle jack (output)– provides the rectangle wave output (±5 V)
31. Reverse jack (input) – a +5 V trigger reverses the current output direction
of the triangle wave
32. Triangle jack (output) – provides the triangle wave output (±4 V)
33. Run/Set jack (input) – Set: set by a 0 V signal the triangle output abiding
to the State value
starts a shot, resp.; this jack is tied by a switching contact to +5 V
34. Co-triangle jack (output) - provides the co-triangle wave output (±4 V)
35. Cosine jack (output) - provides the cosine wave output (±4 V)
36. Sine Buchse (Ausgang) - provides the sine wave output (±4 V)
7.2 Back
Fig. 2 shows the back of the module with consecutively numbered elements.
CS-8 Series DLFO Rev1.3, March 2021
(19)
(20)
,
; Run: a +5 V signal unblocks the oscillator or
-11-
Advertisement
Table of Contents
