Removing The Warming Drawer From The Drawer Housing; Reinstalling The Warming Drawer To The Drawer Housing - Bosch HDIP056U Assembly Instructions Manual

Push the levers on both the hinges up and forward until
5.
they are locked into the slot and flush with the front of
the oven body.
Close and open the door slowly to be sure it is correctly
6.
and securely in place.
8.5 Removing the warming drawer from the
drawer housing
WARNING
To prevent burns, do not remove the drawer while hot.
Be sure the drawer is empty before removing.
▶
The warming drawer has a push-to-open (PTO) mecha-
1.
nism. Press on the center of the warming drawer front
panel to open it.
Pull out the warming drawer to fully open position.
2.
Press down the right drawer release lever
3.
Lift up the left drawer release lever
4.
Firmly pull the drawer straight out
5.
6.
7.
8.6 Reinstalling the warming drawer to the
Requirement: The slides mounted to each side of the
housing wall have two moving components, an inner rail
and a ball bearing carrier which need to be in the proper
orientation for accurate installation and alignment. There is
also a visible locking mechanism located at the rear of
each slide.
1.
⁠ .
⁠ .
⁠ .
Installing the range into the cabinets en-us
Retract the cabinet rails while the drawer is removed.
Grasp both sides of the drawer and carefully remove
the drawer housing, pulling straight and level.
This step may require light to moderate force to com-
pletely remove drawer.
drawer housing
Slide the inner rail to the locked position by pushing it
toward the rear of the housing until it locks in place.
Note: A moderate force pushing on the black plastic
ball carrier locking mechanism is required to activate
the lock. When the drawer is installed, the locking
mechanism prevents the drawer from springing back to
the open position.
17