Replacing The Oven Door; Removing The Warming Drawer; Replacing The Warming Drawer - Bosch HDIPO54UC Installation Manual

Replacing the Oven Door
Removing the Warming Drawer
Holding the door firmly
in both hands, grip it
on either side, not by
the handle.
Tilt the door back
slightly towards you
until it opens about 7"
at the top.
Slide the hinges into
the slots as far as they
will go and then lower
the door straight
down. The angle of
the door may need to
be adjusted slightly to
allow the hinges to
engage properly and
the door to lower into
place. The door
should lower about %"
and stop. If not, the
hinges have not
engaged properly and
the door could fall if it
is released.
A CAUTION
To prevent burns, do not remove drawer while hot.
Be sure the drawer is empty before removing.
Once both hinges are Parts
fully engaged as 4 Housing
described in Step 3,
gently open the door 2 Drawer
until it is fully open. 3 Housing slide
Push the levers on 4 Drawer rail
both the hinges up
and forward until they 1. Pull drawer to fully open position.
are locked into the ; .
slot. flush with the 2. Press down right drawer clip.
front of the oven body. 3. Lift up left drawer clip.
Close and open door 4. Firmly pull the drawer straight out. Retract housing
slowly to be sure it is
correctly and securely
in place.
English 18
slides while drawer is removed.
Replacing the Warming Drawer
1.
2.
Be sure housing slides are pushed inside housing.
Align the drawer rails with the housing slides attached
to the drawer housing.
Firmly push the drawer straight into the drawer housing
until the drawer clicks into place. Note: The drawer has
a "push-to-open'" operation. Pressing the lower center
front of the drawer causes the drawer to self-open.
Open and close drawer to test operation. Note: if the
drawer will not close, verify that the rails on the drawer
are properly aligned to housing slides and that the rail
release levers are properly positioned.
9000989333 Rev D