Troubleshooting Guide - Polygroup RX330 Owner's Manual

Problem
A. Not plugged in
1. Motor doesn't start,
B. GFCI Power Cord Set
p
or kicks on and off
and/or circuit breaker tripped
C. Low voltage
A. Low pool water level
2. No or slow water
B. Clogged inlet/outlet
flow from the
Return Fitting
C. The Filter Cartridge
6
is too dirty
D. Motor Rotor block by dirt
A. Inadequate chlorine level
B. Inadequate pH level
C. The Filter Cartridge
is too dirty
3. Pump is not cleaning
D. The Filter Cartridge
the pool properly e.g.
is damaged
cloudy/green water
E. Water flow is slow
F. Other chemicals required
G. Pool water is too dirty
A. Suction
or Hose
B. Vent Screw
4. Water leakage at
C. Seal Top
D. Pump Body

TROUBLESHOOTING GUIDE

Cause
A. Plug the GFCI Power Cord Set
the RESET button to restart it.
B. Reset your circuit breaker on the electrical panel. If problem persists, have the circuit
j
checked by a qualified electrician.
C. Check and make sure the line voltage is between 105V and 125V.
A. Fill the pool to the FILL LINE. The Suction Fitting
B. Check for obstructions at the Filter Cartridge
a
C. Clean or replace the Cartridge following the steps of FILTER CARTRIDGE USE & CARE (p. 12).
D. Refer to pump servicing instructions to clean dirt.
A. Maintain the chlorine level between 1.0 and 1.6 ppm.
B. Maintain the pH level between 7.3 and 7.8
a
C. Clean or replace the Cartridge following the steps of FILTER CARTRIDGE USE & CARE (p. 12).
a
D. Inspect the Cartridge for holes or tears. If it's visibly damaged, replace it with a new one.
E. Check for obstructions at the Filter Cartridge
F. Have your pool water sample tested by a pool supplies store. You may need to add
other chemicals since water quality varies in different localities.
G. Chemicals are essential to keep the pool water clean. Clean the pool and filter more often.
A. Check that the Hose Clamps
/ Return fittings
2 6
O-rings
connection points
9
replace as needed.
B. Check the Vent Screw O-Ring
e
C. Check the Canister Gasket
t
D1. Check the Canister Gasket
d
D2. Check that the Gasket sits correctly in the groove at the bottom of the Canister
OWNER'S MANUAL
Solution
to a 3-wire grounded power outlet. Then press
j
are properly secured over both the Hoses
q
; adjust and retighten if necessary. Also, check the Hoses for cracks or holes and
k
for damage and replace as needed. Also retighten the Screw.
r
for damage and replace as needed. Also retighten the Seal Top.
u
for damage and replace as needed.
u
must be at least 4" under water.
2
, Suction Fitting or Return Fitting
a 2
, Suction Fitting or Return Fitting
a 2
and their
9
i
.
6
.
6
.
17