Related Manuals for LTE GLC-130S Series
Summary of Contents for LTE GLC-130S Series
- Page 1 GLC-130S Outdoor CPE Series Quick User Guide V1.0 Page 1...
- Page 2 PLEASE READ THESE SAFETY PRECAUTIONS! RF Energy Health Hazard The radio equipment described in this guide uses radio frequency transmitters. Although the power level is low, the concentrated energy from a directional antenna may pose a health hazard.
- Page 3 GLC-130S Series is a high performance LTE CPE (Customer Premises Equipment) p roduct d esigned t o e nable q uick LTE s ervice deployment ...
-
Page 4: Getting Started
2. Getting Started 1) Packing list Upon receiving the product, please unpack the product package carefully. Each product is shipped with the following items: Table 2-1 Packing List ... - Page 5 To power on the device, the outdoor CPE must uses a 48V PoE integrated DC power supply adapter. The power adapters can operate in 90-250V AC range and therefore can be used in different country. Once the device is powered up, the user should wait for about 2 minutes before the device becomes operational.
- Page 6 Header Connection: 3. RF Signal Adjusting n RF Signal Adjusting After the CPE outdoor unit has installed, the direction of antenna’s azimuth and pitch angle needs to adjust for the best signal strength. In near line of sight condition, the CPE will have the best signal when the antenna is directly pointing the base station.
-
Page 7: Managing Cpe Device
“Interface Info” link. The following wireless link information can be displayed. 4. Managing CPE Device GLC-130S Series CPE supports several management interfaces including TELNET, WEB, and TR- 069 for local or remote managements. However normal end user is only provided with WEB based access WEB Login n... - Page 8 The user should ensure that the connected PC have acquired IP address via DHCP from the device. After IP connectivity is established between the PC and CPE device, the user may launch a Web browser and specify http://10.1.1.1 in the address bar. A window will pop up requesting password. Input the user login password and then click the “Log In”...
- Page 9 n LAN Configuration The LAN setting allows user to specify the DHCP server setting for the LAN devices including the pool address, IP and MAC binging and whether DHCP server should be enabled. User is advised to leave the default setting unchanged for quick configuration and smooth device operation.
- Page 10 n Applications Configuration Port Range Forwarding: Certain applications may require to open specific ports in order for it to function correctly. Examples of these applications include servers and certain online games. When a request for a certain port comes in from the Internet, the device will route the data to the computer you specify. Due to security concerns, you may want to limit port forwarding to only those ports you are using, and uncheck the Enable checkbox after you are finished.
- Page 11 n UPnP Setting Forwards: Configure Port forwarding for UPnP. Click the trash sign to delete individual entry. UPnP Service: Allows applications to automatically setup port forwarding. n Maintenance Firmware Upgrade over HTTP: Click on the Browser button to select the firmware file to be uploaded to the device. Page 11...
-
Page 12: Device Reset
Click the Upgrade button to begin the upgrade process. Upgrade must not be interrupted. Old Password: The password currently in use. New Password: The new password must not exceed 63 characters in length and must not include any spaces. Enter the new password a second time to confirm it. -
Page 13: Faq And Troubleshooting
If the problem persists, please contact the operator or distributor for further diagnose. My CPE networking is not working properly. n You may want to check if the LTE connection is up and running properly. You can do this by login the WEB GUI and check the Interface Info page.
Need help?
Do you have a question about the GLC-130S Series and is the answer not in the manual?
Questions and answers