Bourgault AccuSet Quick Reference Manual

Welcome to the Quick Reference Guide for the AccuSet manual override operation for raising and
lowering the drill. Please refer to the Operator's Manual for complete instructions.
In the event that there is an issue with the Bourgault AccuSet Implement Controller ECU, that
prevents the raise and lower operation of the drill, there is a manual override harness provided
to by-pass the ECU.
Important: The intent of this harness is to act as an emergency service tool and should not replace
the operation of the ECU.
OVERRIDE
HARNESS
STORAGE
Bourgault AccuSet Implement Controller ECU (BIC ECU)
Using the AccuSet Manual
Override Harness
1. Ensure a safe state of the drill. Turn off all
hydraulics and remove the tractor key from
the ignition.
2. Carefully take the harness out of the storage
container and unfold.
3. Remove the harness connectors from CH 1,
2, 3, and PWR on the BIC ECU.
4. Plug these connectors into the Manual
Override Harness with their respective labels.
AccuSet Channels pair with CH's 1, 2, and
3 (order not important), and "AccuSet ECU
PWR" to ECU Power.
a. At each of the AccuSet hydraulic blocks at
the base of each axle, you need to unscrew
the Counterbalance Valves to permit the
QDA cylinder to rest on the shims.
P/N 0256-70-01
Assy P/N 0256-70-10
3335 AccuSet Manual Override Quick Reference Guide
POWER
CH1 CH2 CH3
Rocker switch
AccuSet Manual Override Harness
Page 1