Supported Sip Phones - Bizfon 2000 Installation Manual

Bizfon Manual I: Installation Guide
(see Username and Password). You may use either these values or specify new ones.
Press Save to apply the settings for the IP line.
Reset the SIP Phone. After restart, the appropriate configuration will be automatically
downloaded from the Bizfon to the SIP Phone.
Please Note: If you have decided to make the IP phone configuration manually, it is rec-
ommended to select the Other option from the Phone Model drop down list and to make
the configuration manually on the SIP phone also. The SIP phone's configuration is differ-
ent dependent on the SIP phone model. For more information about SIP Phone configura-
tion, refer to the SIP phone manual or user's guide.
Some SIP phones require only reboot for configuration download. Other SIP Phones may
require additional configuration. For example, by default IP Dialog SIP Tone II is in non-
auto-provisioning mode, therefore the user has to manually enable it on the phone.
To make sure the line configuration works properly, do the following:
•
Go to Bizfon Status- SIP Registration status – Registered IP Lines to see if
IP Line registration is successful.
•
Dial *74 to get the line information.
•
Make outgoing and accept incoming calls.
To make the IP line functional (for example, to be able to make/receive calls), refer to the
Step 3: Making/Receiving Calls
te nsions should be attached to the configured IP line.

Supported SIP Phones

Below is the list of SIP phones that can be automatically configured to work with
B izfon2000 and Bizfon4000:
•
Biztouch 5
•
Biztouch 6
•
Biztouch 15
•
Biztouch 16
Bizfon2000 and Bizfon4000; (SW Version 4.1.x)
chapter further in this guide, with the difference that the ex-
TM
,
TM
,
TM
,
TM
.
Step 2-A: Using IP Lines
32