Table of Contents
Advertisement
Biostar T-Series
2.2 S
M
YSTEM
EMORY
A. DDR 2 Modules
1.
Unlock a DIMM slot by pressing the retaining clips outward. Align a DIMM on the
slot such that the notch on the DIMM matches the break on the slot.
2.
Insert the DIMM vertically and firmly into the slot until the retaining chip snaps
back in place and the DIMM is properly seated.
Notes:
To remove the DDR modules, push the ejector tabs at both sides of the slot outward at
the same time, and pull the modules out vertically.
B. Memory Capacity
DIMM Socket Location
DDR Module
DDR2_A1
256MB/512MB/1GB *1
DDR2_A2
256MB/512MB/1GB *1
DDR2_B1
256MB/512MB/1GB *1
DDR2_B2
256MB/512MB/1GB *1
2.3
A. Card and I/O Slots:
Floppy Disk Connector: FDD1
The motherboard provides a standard floppy disk connector that supports
360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector
supports the provided floppy drive ribbon cables.
Hard Disk Connectors: IDE1/IDE2
The motherboard has two 32-bit Enhanced PCI IDE Controllers that provide
PIO Mode 0~5, Bus Master, and Ultra DMA 33/66/100/133 functionality. It has
two HDD connectors IDE1 (primary) and IDE2 (secondary). The IDE
connectors can connect a master and a slave drive, so you can connect up to
four hard disk drives. The first hard drive should always be connected to IDE1.
Total Memory Size
Max is 4GB.
4
P
ERIPHERALS
39
40
TForce4 U 775
34
33
2
1
IDE2
1
2
IDE1
User's Manual
Advertisement
Table of Contents
