Table of Contents
Advertisement
Biostar T-Series
Clear CMOS Header: JCMOS1
By placing the jumper on pin 2-3, it allows user to restore the BIOS safe setting
and the CMOS data, please carefully follow the procedures to avoid damaging the
motherboard.
※ ※ ※ ※
Clear CMOS Procedures:
1. Remove AC power line.
2. Set the jumper to "Pin 2-3 close".
3. Wait for five seconds.
4. Set the jumper to "Pin 1-2 close".
5. Power on the AC.
6. Reset your desired password or clear the CMOS data.
3
1
Pin 1-2 close:
Normal Operation (Default).
3
1
3
1
Pin 2-3 close:
Clear CMOS data.
9
Header for Memory Voltage Customize: JDDR_OV>3V
When processing Memory Voltage Overclocking, please place the jumper to
pin1-2 closed. The Default setting is Pin 2-3 Closed.
Note:
1.
When "JDDR_OV>3V" jumper cap is placed on Pin 2-3, memory voltage can be
manually adjusted under CMOS setup.
2.
When "JDDR_OV>3V" jumper cap is placed on Pin 1-2, memory voltage will be fixed
at 3.3V automatically, and can't be adjusted under COMS setup.
Before setting memory voltage overclocking, please make sure that your DDR supports up
to 3V. (Consult your DDR memory module supplier)
TForce4 U 775
1
3
Pin 1-2 close:
Fixed memory voltage at 3.3V
(Default).
1
3
1
3
Pin 2-3 close:
Enable memory voltage
customize.
User's Manual
Advertisement
Table of Contents
