Introduction; Getting Started - PRESONUS StudioLive III Series Manual

1

Introduction

1 Introduction
2

Getting Started

Your StudioLive Series III console mixer can be used as a hardware controller
for Avid® Pro Tools® using HUI Control Emulation. Once enabled, your
StudioLive Series III console will emulate many HUI Control functions.
We suggest that you use this addendum to familiarize yourself with the
features, applications, and correct connection procedures for your StudioLive
mixer before trying to connect it to your computer to control Pro Tools.
This will help you avoid problems during installation and setup.
This guide will provide instructions on enabling HUI Control Emulation
mode for DAW Control as well as how the HUI Control functions
are mapped to your StudioLive Series III console mixer.
Note: HUI and MCU control emulation modes require Universal Control 2.10 or later
installed on your computer and firmware version 1.10 or later installed on your StudioLive
Series III mixer.
To begin using your StudioLive Series III mixer as a HUI Control
Emulation device, connect it to an available Ethernet port on the same
router to which your computer is connected (wired or wirelessly)
or directly to an Ethernet connection on your computer.
Audio Control
Please Note: At the time of publication, remote control over USB is not supported. You
must network your mixer and your computer to use DAW mode, in addition to connecting
USB for audio transport so that your StudioLive can be used as an audio interface.
Important: If you are hardwiring your computer to the same router
as your mixer, you must disable the wireless connection on your
computer. UCNET does not support dual network connections.
Note: Ethernet-to-Thunderbolt and Ethernet-to-USBC adapters are also supported.
Ethernet-to-USB adapters will not allow your computer to network to a StudioLive mixer.
StudioLive™ Series III
Studio One HUI DAW Addendum
StudioLive 32SC
Laptop running Pro Tools
1