Biostar M7TDB User Manual page 62

Chapter 2
Wake-Up by PCI card
When you select Enabled, a PME signal from PCI card returns the system to Full
On state.
The Choices: Disabled (default), Enabled.
Power On by Ring
An input signal on the serial Ring Indicator (RI) line (in other words, an incoming
call on the modem) awakens the system from a soft off state.
The Choices: Disabled (default), Enabled.
WakeUp On LAN
To use this function, you need a LAN add-on card which support power on
function. It should also support the wake-up on LAN jumper.
The Choices: Disabled (default), Enabled.
Resume by Alarm
This function is for setting date and time for your computer to boot up. During
Disabled, you cannot use this function. During Enabled, Choose the Date and
Time Alarm:
Date (of Month) Alarm
Time (hh:mm:ss) Alarm
Note: If you have change the setting, you must let the system boot up until it
goes to the operating system, before this function will work.
Reload Global Timer Events
Reload Global Timer Events are I/O events whose occurrence can prevent the
system from entering a power saving mode or can awaken the system from such a
mode. In effect, the system remains alert for anything, which occurs to a device,
which is configured as Enabled, even when the system is in a power down mode.
Primary IDE 0/1
Secondary IDE 0/1
FDD, COM, LPT Port
PCI PIRQ [A-D]#
You can choose which month the system
will boot up.
You can choose shat hour, minute and
second the system will boot up.
2-25
BIOS Setup