East Coast Gate Operators ECGO-GKP Instructions Manual page 4

Connect a 12 volt DC power supply to terminals marked "12V~24V
AC/DC"
The ECGO-GKP is designed to work with power supplies 12V~24V
AC/DC.
The power supply should be capable of supplying a constant current
of no less than 1amp, a transformer is supplied
Be very careful to not damage antenna wire and use the supplied gasket for water tight
Seal damage to Antenna will cause failure and void warranty
Push red reset at same time jumping PB and GND till you hear Dou" tones
release all at once
LED Status " Indicator
LED
Red (standby)
Red (using)
• LED 'Network "Indicator
LED
Red (ready)
Red (searching)
Red (busy)
• LED " Power " Indicator
LED
Red (power on)
Red (power off)
Hard reset(for restoring unit to factory)
Status
Flashing
Solid
Status
Flashes once per 3 seconds
Flashes once per second
Solid
Status
Solid
Off
Power Supply
Page 4