East Coast Gate Operators ECGO-GKP Instructions Manual page 3

The ECGO-G is a telephone entry system, installed at the entrance of a building or outside gate area. It is
an ideal product replacing the traditional door/gate phone. It allows you to speak with visitors standing at
the entrance of your company or house entrance from a remote location. A visitor, by simply pressing the
Call button establishes a mobile call with you. During the call you will be able to activate two devices,
whether it is gate or activating / de-activating any other devices by pressing appropriate digits.
This ECGO-GKP gives you the opportunity not only to know who is waiting at the entrance from a remote
location but also to control the access point. Use of ECGO-GKP at your company or house does not require
any special installation and wiring. Simply install the ECGO-GKP and connect out put to gate operator and
power supply.
Operating Voltage
Operating Current
Frequency
Humidity
Operating Temperature
Insert the SIM card into the SIM card holder and close it carefully. After Sims card is
installed. Power unit up, the unit will beep, until it connects to the cell tower.
Standard size sim card or Mini with adapter is acceptable Card AT&T or T-Mobile
Needs Voice and Text Messaging only NO 4G DATA Needed
Card must be activated at store. Make sure you get the Phone number to the Card
ECGO-GKP INTRODUCTION
ECGO-GKP Specification
SIM card Standard Size Only
or any GSM network only 3G no 4G data needed
12 to 24 Volt DC/AC ONLY""
Maximum 250mA, Typically 55mA
850/900/1800/1900 or 900/1800 MHz
Less than 80% RH
-20℃ to 50℃
Page 3